![]() ![]() The type of protocol a network’s Access Point is using The amount of interference that is in a signal The maximum speed an Access Point can send and receive data *Note: Specific APs may force the users device to the best RSSI, so users will Join an AP, only to be immediately moved to the ones the APs choose.Ī time stamp for when the last time a device was detected When networks are checked, they will display in the various graphsĪllows the user to connect to a specific network* The frequency range that a network is operating on The specific channel a network is operating on The Country Code of a network (if given by the Access Point) The MAC address or unique address that identifies each specific device Whether the network is setup as and Ad-Hoc or not Columns can be toggled on/off from the preferences menu. The network that the user is connected to will be highlighted in this section with a yellow hue. These columns can all be rearranged except for the Check Boxes, and SSID. The information gathered is separated into columns. Simply enter the Channel (add multiple by separating by commas) / Signal fields and hit enter on the keyboard to activate those filters. The FILTER button on the right-hand side opens up a secondary filter. Vendor (this can be updated via Help menu and choosing Update Vendor OUI and).Use SHIFT and COMMAND keys to select multiple values. Users can select an option and it will be filter on the right-hand table. The left side filter is accessed by the tab icon in the upper left-hand corner. These features can be utilized before, during, or after the current scan has been performed. ![]() The filters are very helpful when the user is trying to narrow down the results in a high-volume area. This ensures that the user has refreshed data as quickly as possible. The default setting is 5 seconds for every scan, which means that WiFi Scanner will run tests every 5 seconds until the user pauses or stops the scan. Users can filter results, gain more information about each network, view network congestion, as well as test speeds on the network the user is connected. The Scan tab allows the user to scan for networks using the computer’s built-in capabilities. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |